45 lines
1.6 KiB
ReStructuredText
45 lines
1.6 KiB
ReStructuredText
Quick Start
|
|
===========
|
|
|
|
To get started with **trinteract**, connect an **3.3v** arduino pro micro to the board as shown in the picture along with the 3D printed top. If you're building your own kit head over to the :doc:`🛠️ Build Your Own </build_your_own/overview>` section.
|
|
|
|
.. admonition:: Important
|
|
:class: attention
|
|
|
|
trinteract is only compatible with 3.3 volts, any higher voltage could fry the sensor
|
|
|
|
.. image:: Figure1.png
|
|
:align: center
|
|
|
|
.. It can track movement in all 3 axes, and you can customize it further by following the
|
|
.. instructions on this website.
|
|
|
|
|
|
.. note::
|
|
.. The zxyKit is pre-configured to work with **Blender** out of the box, If you want to use it with other software
|
|
.. visit the :doc:`Configuration` page.
|
|
|
|
.. :abbr:`HTML (Hyper Text Markup Language)`
|
|
|
|
.. Next, launch the interactive tutorial on figma following the link below.
|
|
|
|
.. - To get started:
|
|
|
|
.. - Attach the purple board to the Arduino as shown in the picture.
|
|
.. - Connect the board to your computer using the micro usb cable.
|
|
.. - Launch Blender and go into fly mode from the ``View ‣ Navigation`` menu.
|
|
.. Or using the ``Shift`` + ``accent grave`` shortcut.
|
|
|
|
On Windows, Your computer will recognize trinteract as a game controller. To check if it's recognized go to:
|
|
``Control Panel`` → ``Devices and Printers`` → ``Set up USB game controllers`` and click ``Properties``
|
|
|
|
.. image:: Figure2.png
|
|
:width: 45%
|
|
|
|
.. image:: Figure3.gif
|
|
:width: 45%
|
|
|
|
.. note::
|
|
If trinteract isn't recognized on your computer you can visit the Troubleshooting guide here
|
|
|